Quick Start Guide

RIGOL
DG1000Z Quick Guide 7
Output Square with frequency from 1μHz to 25MHz and variable
duty cycle.
— The backlight goes on when this function is selected.
— You can set the parameters for square waveform including
Freq/Period, Ampl/HiLevel, Offset/LoLevel, Duty Cycle and
Start Phase.
Output Ramp with frequency from 1μHz to 1MHz and variable
symmetry.
— The backlight goes on when this function is selected.
— You can set the parameters for ramp waveform including
Freq/Period, Ampl/HiLevel, Offset/LoLevel, Symmetry and
Start Phase.
Output Pulse with frequency from 1μHz to 25MHz and variable
pulse width and edge times.
— The backlight goes on when this function is selected.
—
You can set the parameters for pulse including Freq/Period,
Ampl/HiLevel, Offset/LoLevel, Width/Duty, Leading, Trailing
and Start Phase.
Output Gaussian Noise with 60MHz bandwidth.
— The backlight goes on when this function is selected.
— You can set the parameters for Noise including
Ampl/HiLevel and Offset/LoLevel.
Output Arbitrary waveform with frequency from 1μHz to 20MHz.
— Support two output modes:
Sample Rate and Frequency.
— Up to 160 built-in waveforms.
— The backlight goes on when this function is selected.
— You can set the parameters for Arb waveform including
Freq/Period, Ampl/HiLevel, Offset/LoLevel and Start Phase.
14. Function Keys
Output multiple types of modulated waveforms.
— Support multiple modulation types: AM, FM, PM, ASK, FSK,
PSK and PWM.
— Support internal and external modulation sources.
— The backlight goes on when this function is selected.
Output Sweep waveform for Sine, Square, Ramp and Arb
(except DC).
— 3 Sweep types: Linear, Log and Step.
— 3 types of trigger sources: Internal, External and Manual.
— Provide frequency mark function used to control the status
of the sync signal.