Quick Start Guide

RIGOL
6 DG1000Z Quick Guide
Note
To avoid damage to the instrument, the input signal voltage cannot
exceed ±7Vac+dc.
9. Counter
Used to turn the counter on or off.
— Press this key to turn the counter on, the backlight goes on and the
indicator at the left of Counter blinks.
— Press this key again to turn the counter off and the backlight goes off.
Note: the sync signal of CH2 will be disabled if the counter is turned on and it
will be enabled after the counter is turned off.
10. Direction Keys
— Used to move the cursor to select the digit to be edited when setting
parameter using knob.
— Used to delete the number at the left of the cursor when inputting
parameter using numeric keyboard.
— Used to unfold or fold the selected directory when storing or reading file.
— Used to move the cursor to select the desired character in filename input
area when editing filename.
11. Knob
— Used to increase (clockwise) or decrease (counterclockwise) the value
marked by the cursor when setting parameter using knob.
— Used to select the storage location when storing a file or used to select the
file to be read when reading file.
— Used to select a character from the virtual keyboard when editing filename.
— Used to select a desired built-in arbitrary waveform from Arb  Select
Wform  BuiltIn.
12. Numeric Keyboard
The numeric keyboard consists of number keys (0 to 9), decimal point (.) and
sign key (+/-) and is used to set the parameters.
Note:
 The sign key is used to switch between uppercase and lowercase inputs.
 Press the decimal point twice to save the content displayed in the user
interface in the USB storage device in *.Bmp format.
13. Waveform Keys
Output Sine with frequency from 1μHz to 60MHz.
— The backlight goes on when this function is selected.
— You can set the parameters for sine waveform including
Freq/Period, Ampl/HiLevel, Offset/LoLevel and Start Phase.