Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DG1000Z Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 Front Panel Operations
- To Output Basic Waveform
- To Select Output Channel
- To Select Basic Waveform
- To Set Frequency/Period
- To Set Amplitude/High Level
- To Set Offset/Low Level
- To Set Start Phase
- Align Phase
- To Set Duty Cycle (Square)
- To Set Symmetry (Ramp)
- To Set Pulse Width/Duty Cycle (Pulse)
- To Set Leading/Trailing Edge Time (Pulse)
- To Enable Output
- Example: To Output Sine Waveform
- To Output Arbitrary Waveform
- To Output Harmonic
- Modulation
- Sweep
- Burst
- Counter
- Store and Recall
- Utility and System Settings
- To Install the Option
- To Lock the Keyboard
- To Output Basic Waveform
- Chapter 3 Remote Control
- Chapter 4 Troubleshooting
- Chapter 5 Specifications
- Chapter 6 Appendix
- Index
Chapter 6 Appendix RIGOL
DG1000Z User’s Guide 6-3
Note
[1]
:
Full power bandwidth refers to the maximum frequency when the power amplifier can generate AC
output with the maximum possible amplitude and without distortion.
Full power bandwidth
max
2 V
SR
FPB
π
=
SR: Slew Rate (output slew rate)
Vmax: the maximum amplitude without distortion that the amplifier can output
Note
[2]
:
Definition of Slew Rate: input a large step-function signal into the amplifier, the output slope of the
signal is saturated to a constant at a certain position. This constant is called the Slew Rate of the
amplifier.
Note
[3]
:
The specifications above are all specifications under 25℃. The range of the environment
temperature for PA1011 is from 0℃ to +35℃ and when the environment temperature is greater
than 35℃, it is recommended that users reduce the output power and the working frequency of
PA1011.