Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DG1000Z Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 Front Panel Operations
- To Output Basic Waveform
- To Select Output Channel
- To Select Basic Waveform
- To Set Frequency/Period
- To Set Amplitude/High Level
- To Set Offset/Low Level
- To Set Start Phase
- Align Phase
- To Set Duty Cycle (Square)
- To Set Symmetry (Ramp)
- To Set Pulse Width/Duty Cycle (Pulse)
- To Set Leading/Trailing Edge Time (Pulse)
- To Enable Output
- Example: To Output Sine Waveform
- To Output Arbitrary Waveform
- To Output Harmonic
- Modulation
- Sweep
- Burst
- Counter
- Store and Recall
- Utility and System Settings
- To Install the Option
- To Lock the Keyboard
- To Output Basic Waveform
- Chapter 3 Remote Control
- Chapter 4 Troubleshooting
- Chapter 5 Specifications
- Chapter 6 Appendix
- Index
Chapter 5 Specifications RIGOL
DG1000Z User’s Guide 5-1
Chapter 5 Specifications
Unless otherwise specified, all specifications can be guaranteed if the following two
conditions are met.
The generator is within the calibration period and has performed self-calibration.
The generator has been working continuously for at least 30 minutes under the
specified temperature (18℃~28℃).
All the specifications are guaranteed unless those marked with “typical”.
Model
DG1022Z
DG1032Z
DG1062Z
Channel 2 2 2
Maximum Frequency 25MHz 30MHz 60MHz
Sample Rate
200MSa/s
Waveforms
Basic waveforms Sine, Square, Ramp, Pulse, Noise
Built-in Arbitrary
Waveforms
160 kinds, including Sinc, Exponential Rise, Exponential
Fall, ECG, Gauss, HaverSine, Lorentz, Dual-Tone, etc.
Frequency Characteristics
Sine 1μHz to 25MHz 1μHz to 30MHz 1μHz to 60MHz
Square
1μHz to 25MHz
1μHz to 25MHz
1μHz to 25MHz
Ramp
1μHz to 500kHz
1μHz to 500kHz
1μHz to 1MHz
Pulse
1μHz to 15MHz
1μHz to 15MHz
1μHz to 25MHz
Harmonic 1μHz to 10MHz 1μHz to 10MHz 1μHz to 20MHz
Noise (-3dB)
25MHz
bandwidth
30MHz
bandwidth
60MHz
bandwidth
Arbitrary Waveform 1μHz to 10MHz 1μHz to 10MHz 1μHz to 20MHz
Resolution 1μHz
Accuracy
±1ppm of the settings, 18℃ to 28℃
Sine Wave Spectrum Purity
Harmonic Distortion
Typical (0dBm)
DC-10MHz (included): <-65dBc
10MHz-30MHz (included): <-55dBc
30MHz-60MHz (included): <-50dBc
Total Harmonic
Distortion
<0.075% (10Hz-20kHz, 0dBm)
Spurious
(non-harmonic)
Typical (0dBm)
≤10MHz: <-70dBc
>10MHz: <-70dBc+6dB/octave
Phase Noise
Typical (0dBm, 10kHz deviation)
10MHz: <-125dBc/Hz