Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DG1000Z Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 Front Panel Operations
- To Output Basic Waveform
- To Select Output Channel
- To Select Basic Waveform
- To Set Frequency/Period
- To Set Amplitude/High Level
- To Set Offset/Low Level
- To Set Start Phase
- Align Phase
- To Set Duty Cycle (Square)
- To Set Symmetry (Ramp)
- To Set Pulse Width/Duty Cycle (Pulse)
- To Set Leading/Trailing Edge Time (Pulse)
- To Enable Output
- Example: To Output Sine Waveform
- To Output Arbitrary Waveform
- To Output Harmonic
- Modulation
- Sweep
- Burst
- Counter
- Store and Recall
- Utility and System Settings
- To Install the Option
- To Lock the Keyboard
- To Output Basic Waveform
- Chapter 3 Remote Control
- Chapter 4 Troubleshooting
- Chapter 5 Specifications
- Chapter 6 Appendix
- Index
Chapter 3 Remote Control RIGOL
DG1000Z User’s Guide 3-9
If resources cannot be found automatically:
Select the GPIB card address of the PC from the comboBox of “GPIB0::” and
select the GPIB address set in the generator from the comboBox of
“0::INSTR”.
Click “Test” to check whether the GPIB communication works normally; if
not, please follow the corresponding prompt messages to solve the
problem.
5. View device resource
Click
to return back to the main interface of Ultra Sigma. The
resources found will appear under the “RIGOL Online Resource” directory as
shown in the figure below.
6. Communication Test
Right-click the resource name “DG1062Z (GPIB0::16::INSTR)” to select “SCPI
Panel Control” to turn on the remote command control panel through which you
can send commands and read data.