Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DG1000Z Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 Front Panel Operations
- To Output Basic Waveform
- To Select Output Channel
- To Select Basic Waveform
- To Set Frequency/Period
- To Set Amplitude/High Level
- To Set Offset/Low Level
- To Set Start Phase
- Align Phase
- To Set Duty Cycle (Square)
- To Set Symmetry (Ramp)
- To Set Pulse Width/Duty Cycle (Pulse)
- To Set Leading/Trailing Edge Time (Pulse)
- To Enable Output
- Example: To Output Sine Waveform
- To Output Arbitrary Waveform
- To Output Harmonic
- Modulation
- Sweep
- Burst
- Counter
- Store and Recall
- Utility and System Settings
- To Install the Option
- To Lock the Keyboard
- To Output Basic Waveform
- Chapter 3 Remote Control
- Chapter 4 Troubleshooting
- Chapter 5 Specifications
- Chapter 6 Appendix
- Index
Chapter 3 Remote Control RIGOL
DG1000Z User’s Guide 3-7
4. View device resource
The resources found will appear under the “RIGOL Online Resource” directory as
shown in the figure below.
5. Communication test
Right click the resource name “DG1062Z (TCPIP::172.16.3.82::INSTR)” to
select “SCPI Panel Control” to turn on the remote command control panel
through which you can send commands and read data.
6. Load LXI webpage
As this generator conforms to LXI Core 2011 Device standards, you can load LXI
webpage through Ultra Sigma (right-click the resource name and select
LXI-Web) or directly inputting the IP address in the browser. Various important
information about the instrument (including the model, manufacturer, serial
number, description, MAC address and IP address etc.) will be displayed on the
webpage.