Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DG1000Z Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 Front Panel Operations
- To Output Basic Waveform
- To Select Output Channel
- To Select Basic Waveform
- To Set Frequency/Period
- To Set Amplitude/High Level
- To Set Offset/Low Level
- To Set Start Phase
- Align Phase
- To Set Duty Cycle (Square)
- To Set Symmetry (Ramp)
- To Set Pulse Width/Duty Cycle (Pulse)
- To Set Leading/Trailing Edge Time (Pulse)
- To Enable Output
- Example: To Output Sine Waveform
- To Output Arbitrary Waveform
- To Output Harmonic
- Modulation
- Sweep
- Burst
- Counter
- Store and Recall
- Utility and System Settings
- To Install the Option
- To Lock the Keyboard
- To Output Basic Waveform
- Chapter 3 Remote Control
- Chapter 4 Troubleshooting
- Chapter 5 Specifications
- Chapter 6 Appendix
- Index
RIGOL Chapter 2 Front Panel Operations
2-110 DG1000Z User’s Guide
Rear Panel:
CAUTION
Do not use any other adapters to supply power for PA1011, or else it may
cause degradation or perpetual damage.
CAUTION
Please make sure the vents at both sides and the fan aperture at the rear
panel are visible in operation for normal working.
PA1011 Accessories:
Name
Qty.
Description
Power Cord
1
Connect the AC into the power adaptor.
AC Adaptor 1 Output 12V, 4A signal.
USB Cable 1 Connect PA1011 with DG1000Z.
BNC Cable 1 Connect PA1011 with DG1000Z.
CD-ROM
1
Provide the PC software installation program of PA1011.
USB Device Power In Fan Aperture