Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DG1000Z Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 Front Panel Operations
- To Output Basic Waveform
- To Select Output Channel
- To Select Basic Waveform
- To Set Frequency/Period
- To Set Amplitude/High Level
- To Set Offset/Low Level
- To Set Start Phase
- Align Phase
- To Set Duty Cycle (Square)
- To Set Symmetry (Ramp)
- To Set Pulse Width/Duty Cycle (Pulse)
- To Set Leading/Trailing Edge Time (Pulse)
- To Enable Output
- Example: To Output Sine Waveform
- To Output Arbitrary Waveform
- To Output Harmonic
- Modulation
- Sweep
- Burst
- Counter
- Store and Recall
- Utility and System Settings
- To Install the Option
- To Lock the Keyboard
- To Output Basic Waveform
- Chapter 3 Remote Control
- Chapter 4 Troubleshooting
- Chapter 5 Specifications
- Chapter 6 Appendix
- Index
Chapter 2 Front Panel Operations RIGOL
DG1000Z User’s Guide 2-109
Front Panel:
Status Indicator
Power: red light on, indicating successful power connection.
Output: green light on, indicating that PA output is turned on.
Link: yellow light on, indicating successful USB connection.
CAUTION
The input impedance of the instrument Zi is 50kΩ, and the range of
voltage is from -10V to +10V or form -1.25V to +1.25V separately while
the voltage gain is set to X1 or X10.
Inputs that exceed these ranges may cause damages to the instrument or
other hazards.
CAUTION
The output impedance of the instrument Zo is less than 2Ω, and the range
of output voltage is from -12V to +12V. Although the amplifier actually
enables to output voltages up to ±12.5V, the total wave harmonic
distortion may increase.
Status Indicator Signal Output Signal Input