Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DG1000Z Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 Front Panel Operations
- To Output Basic Waveform
- To Select Output Channel
- To Select Basic Waveform
- To Set Frequency/Period
- To Set Amplitude/High Level
- To Set Offset/Low Level
- To Set Start Phase
- Align Phase
- To Set Duty Cycle (Square)
- To Set Symmetry (Ramp)
- To Set Pulse Width/Duty Cycle (Pulse)
- To Set Leading/Trailing Edge Time (Pulse)
- To Enable Output
- Example: To Output Sine Waveform
- To Output Arbitrary Waveform
- To Output Harmonic
- Modulation
- Sweep
- Burst
- Counter
- Store and Recall
- Utility and System Settings
- To Install the Option
- To Lock the Keyboard
- To Output Basic Waveform
- Chapter 3 Remote Control
- Chapter 4 Troubleshooting
- Chapter 5 Specifications
- Chapter 6 Appendix
- Index
RIGOL Chapter 2 Front Panel Operations
2-106 DG1000Z User’s Guide
recommended that users acquire an available default gateway from their
network administrator.
Press Default Gateway and use the direction keys and numeric keyboard or
knob to enter your desired gateway address. The setting is stored in non-volatile
memory and will be automatically loaded when the generator is powered on the
next time if DHCP and AutoIP are set as “Off”.
To Set DNS Service
In ManualIP mode, the DNS could be manually set.
The DNS format is nnn.nnn.nnn.nnn, wherein the first nnn ranges from 1 to 223
(except 127) and the other three nnn range from 0 to 255. It is recommended
that users acquire an available DNS address from their network administrator.
Press DNS Service and use the direction keys and numeric keyboard or knob to
enter your desired DNS address. The setting is stored in non-volatile memory
and will be automatically loaded when the generator is powered on the next
time if DHCP and AutoIP are set as “Off”.
Default Configuration
Press Default Config and the prompt message “Restore network settings to preset
values of LXI?” is displayed. Press OK to restore the network parameters to their
default values. By default, DHCP and AutoIP are enabled and ManualIP is disabled.
Current Configuration
Press Current Config to examine the MAC address of the current instrument, the
current LAN parameters and LAN status information.
OK
Press OK to enable the current setting of LAN parameters.