Instructions

Chapter 2 Front Panel Operations RIGOL
DG1000Z User’s Guide 2-101
generators (“External” clock) respectively, and finally set the output frequencies
of all the generators as a same value to realize synchronization among multiple
instruments.
Number Format
You can set the display format of the decimal point and thousands separator in
number parameters. This setting is stored in non-volatile memory. Press Utility 
System  Number Format to enter the number format setting interface.
 Decimal Point: could be set as dot “.” or comma “,”. The default is dot “.”.
 Thousands separator: could be set as “,”, “Space” or “None” when decimal point
is set as “.”; could be set as “.”, “Space” or “None” when decimal point is set as
“,”.
Number display format has 6 combinations as shown in the figure below.
Dot + Comma
Dot + Space
Dot + None
Comma + Dot
Comma + Space
Comma + None
Note: decimal point and thousands separator can not be set as dot or comma at the
same time.
Beeper
When the beeper in DG1000Z is enabled, a beep is generated when an error occurs
during front panel or remote operation.
Press Utility  System  Beep to select “On” or “Off” and the default is “On”.
Screen Saver
Enable or disable screen saver mode. Press Utility  System  Scrn Svr to select
“On” or “Off” and the default is “On”.