Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DG1000Z Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 Front Panel Operations
- To Output Basic Waveform
- To Select Output Channel
- To Select Basic Waveform
- To Set Frequency/Period
- To Set Amplitude/High Level
- To Set Offset/Low Level
- To Set Start Phase
- Align Phase
- To Set Duty Cycle (Square)
- To Set Symmetry (Ramp)
- To Set Pulse Width/Duty Cycle (Pulse)
- To Set Leading/Trailing Edge Time (Pulse)
- To Enable Output
- Example: To Output Sine Waveform
- To Output Arbitrary Waveform
- To Output Harmonic
- Modulation
- Sweep
- Burst
- Counter
- Store and Recall
- Utility and System Settings
- To Install the Option
- To Lock the Keyboard
- To Output Basic Waveform
- Chapter 3 Remote Control
- Chapter 4 Troubleshooting
- Chapter 5 Specifications
- Chapter 6 Appendix
- Index
RIGOL Chapter 2 Front Panel Operations
2-96 DG1000Z User’s Guide
ASK Rate 100Hz
Modulation Amplitude 2Vpp
ASK Polarity
Pos
FSK Modulation
Modulation Source
Int
FSK Rate 100Hz
Hop Frequency 10kHz
FSK Polarity Pos
PSK Modulation
Modulation Source
Int
PSK Rate 100Hz
PSK Phase 180°
PSK Polarity Pos
PWM Modulation
Modulation Source
Int
Modulating Waveform Shape
Sine
Modulation Frequency 100Hz
Width Deviation 200μs
Duty Cycle Deviation 20%
Sweep
Sweep Type
Linear
Sweep Time 1s
Return Time 0s
Start Frequency 100Hz
Stop Frequency
1kHz
Center Frequency
550Hz
Frequency Span
900Hz
Start Hold 0s
Stop Hold 0s
Mark Frequency State Off
Mark Frequency
550Hz
Trigger Source
Int
Trigger Output Off
SlopeIn Leading
Step Number 2
Burst
Burst Mode
N Cycle
Cycle Number 1
Burst Period 10ms
Gated Polarity Pos
Trigger Source
Int
Trigger Output
Off