Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DG1000Z Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 Front Panel Operations
- To Output Basic Waveform
- To Select Output Channel
- To Select Basic Waveform
- To Set Frequency/Period
- To Set Amplitude/High Level
- To Set Offset/Low Level
- To Set Start Phase
- Align Phase
- To Set Duty Cycle (Square)
- To Set Symmetry (Ramp)
- To Set Pulse Width/Duty Cycle (Pulse)
- To Set Leading/Trailing Edge Time (Pulse)
- To Enable Output
- Example: To Output Sine Waveform
- To Output Arbitrary Waveform
- To Output Harmonic
- Modulation
- Sweep
- Burst
- Counter
- Store and Recall
- Utility and System Settings
- To Install the Option
- To Lock the Keyboard
- To Output Basic Waveform
- Chapter 3 Remote Control
- Chapter 4 Troubleshooting
- Chapter 5 Specifications
- Chapter 6 Appendix
- Index
Chapter 2 Front Panel Operations RIGOL
DG1000Z User’s Guide 2-89
Waveform Summing
1. To Enable Waveform Summing Function
Press Utility Channel Set Sum Wforms Switch, select “On” to
enable the waveform summing function and sum a specified waveform on the
current waveform or select “Off” to disable the waveform summing function.
Note: this function is valid only for the basic waveforms.
2. To Select Sum Source
Press Utility Channel Set Sum Wforms Sum Source to select the
desired waveform to be summed on the current waveform.
3. Sum Frequency
Set the frequency of waveform to be summed on the current waveform. Press
Utility Channel Set Sum Wforms Sum Frequency to input the
desired value using the numeric keyboard and select the desired unit from the
pop-up menu. The range is related to the currently selected waveform.
4. Sum Ratio
Set the ratio of the amplitude of the waveform to be summed on the current
waveform relative to that of the current waveform. Press Utility Channel
Set Sum Wforms Sum Ratio to input the desired value using the
numeric keyboard and select the unit % from the pop-up menu.