Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DG1000Z Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 Front Panel Operations
- To Output Basic Waveform
- To Select Output Channel
- To Select Basic Waveform
- To Set Frequency/Period
- To Set Amplitude/High Level
- To Set Offset/Low Level
- To Set Start Phase
- Align Phase
- To Set Duty Cycle (Square)
- To Set Symmetry (Ramp)
- To Set Pulse Width/Duty Cycle (Pulse)
- To Set Leading/Trailing Edge Time (Pulse)
- To Enable Output
- Example: To Output Sine Waveform
- To Output Arbitrary Waveform
- To Output Harmonic
- Modulation
- Sweep
- Burst
- Counter
- Store and Recall
- Utility and System Settings
- To Install the Option
- To Lock the Keyboard
- To Output Basic Waveform
- Chapter 3 Remote Control
- Chapter 4 Troubleshooting
- Chapter 5 Specifications
- Chapter 6 Appendix
- Index
Chapter 2 Front Panel Operations RIGOL
DG1000Z User’s Guide 2-83
Utility and System Settings
Press Utility at the front panel to open the operation interface as shown in the
figure below. This interface displays the output configuration, coupling configuration
and system parameters of the currently selected channel.
Figure 2-20 Utility Interface
Channel Set: Set the output parameters of CH1 and CH2.
Coupling Set:
Set the channel coupling parameters.
Channel Copy:
Set the channel copy parameters.
Set To Default: Restore the instrument to its default state.
Language:
Set the system language.
System Info:
View the model, serial number and software version number.
System:
Set parameters relative to the system.
I/O Config:
Set the remote interface parameters.
Print Set:
Set print parameters.
Test Cal:
View the calibration information and set parameters relative
to the calibration.
PA Set:
Set the power amplifier parameters.