Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DG1000Z Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 Front Panel Operations
- To Output Basic Waveform
- To Select Output Channel
- To Select Basic Waveform
- To Set Frequency/Period
- To Set Amplitude/High Level
- To Set Offset/Low Level
- To Set Start Phase
- Align Phase
- To Set Duty Cycle (Square)
- To Set Symmetry (Ramp)
- To Set Pulse Width/Duty Cycle (Pulse)
- To Set Leading/Trailing Edge Time (Pulse)
- To Enable Output
- Example: To Output Sine Waveform
- To Output Arbitrary Waveform
- To Output Harmonic
- Modulation
- Sweep
- Burst
- Counter
- Store and Recall
- Utility and System Settings
- To Install the Option
- To Lock the Keyboard
- To Output Basic Waveform
- Chapter 3 Remote Control
- Chapter 4 Troubleshooting
- Chapter 5 Specifications
- Chapter 6 Appendix
- Index
Chapter 2 Front Panel Operations RIGOL
DG1000Z User’s Guide 2-77
Browser Type
Press Store Browser to switch between “Dir” and “File”. Use the knob to select
the desired directory or file.
Dir: when this type is selected, use the knob to switch between C Disk and D
Disk (when USB storage device is inserted).
File: when this type is selected, use the knob to switch files or folders under the
current directory.
File Operation
When “File” is selected as the browser type, users can perform a series of operations
on files including Save, Read, Copy, Paste, Delete and New Folder.
Save
1. To Select File Type
Follow the introduction in “File Type
” to select the type of files to be saved as.
Only state file and arb file can be saved locally. If the curremt file is “Arb File”,
press Arb Edit Wform Save to save it.
2. To Open the Filename Input Interface
Press Browser to select “File” and then press Save to enter the filename input
interface as shown in the figure below.
Figure 2-18 Filename Input Interface (English)
Filename Input Area Virtual Soft Keyboard