Instructions

RIGOL Chapter 2 Front Panel Operations
2-66 DG1000Z User’s Guide
Figure 2-10 N Cycle Burst
For N cycle burst, “Int”, “Ext” or “Manual” trigger source could be used. Besides, you
can also set the “Burst Period” (internal trigger), “Delay”, “SlopeIn” (external
trigger) and “TrigOut” (internal and manual trigger).
Infinite Burst
In Infinite mode, the cycle number of the waveform is set as an infinite value. The
generator outputs a continuous waveform after receiving trigger signal. Waveform
functions that support infinite burst include Sine, Square, Ramp, Pulse and arbitrary
waveform (except DC).
When Burst is enabled, press Type to select “Infinite” and the instrument will set
the trigger source to “Manual” automatically. An infinite cycle burst sketch will
appear on the screen.
Figure 2-11 Infinite Burst
For infinite burst, “Ext” or “Manual” trigger source could be used. Besides, users can
set the “Delay”, “SlopeIn” (external trigger) and “TrigOut” (manual trigger).
Gated Burst
In Gated Burst Mode, the generator controls the waveform output according to the
external signal level from the [CH1/Sync/Ext Mod/Trig/FSK] connector at the
rear panel. Waveform functions which support gated burst are Sine, Square, Ramp,
Pulse, Noise and arbitrary waveforms (except DC).
When Burst is enabled, press Type to select “Gated” and then press Polarity to set
the gated polarity as “Pos” (or “Neg”). The generator outputs burst waveform only
when the gated signal is positive (or negative).