Datasheet

Model DG1022Z DG1032Z DG1062Z
Channel 2 2 2
Max Frequency 25 MHz 30 MHz 60 MHz
Sample Rate 200 MSa/s
Waveform
Basic Waveform Sine, Square, Ramp, Pulse, Noise
Built-in Arbitrary Waveform
160 kinds, including Sinc, Exponential Rise, Exponential Fall, ECG, Gauss, HaverSine, Lorentz,
Dual-Tone, etc.
Frequency Characteristics
Sine 1 μHz to 25 MHz 1 μHz to 30 MHz 1 μHz to 60 MHz
Square 1 μHz to 25 MHz 1 μHz to 15 MHz 1 μHz to 25 MHz
Ramp 1 μHz to 500 kHz
1 μHz to 500 kHz
1 μHz to 1 MHz
Pulse 1 μHz to 15 MHz 1 μHz to 15 MHz 1 μHz to 25 MHz
Harmonic 1uHz to 10 MHz 1 μHz to 10 MHz 1uHz to 20 MHz
Noise (-3dB) 25 MHz bandwidth 30 MHz bandwidth 60 MHz bandwidth
Arbitrary Waveform 1 μHz to 10 MHz 1 μHz to 10 MHz 1 μHz to 20 MHz
Resolution 1 μHz
Accuracy ±1 ppm of the setting value, 18
℃
to 28
℃
Sine Wave Spectrum Purity
Harmonic Distortion
Typical (0 dBm)
DC-10 MHz (included): <-65 dBc
10 MHz to 30 MHz (included): <-55 dBc
30 MHz to 60 MHz (included): <-50 dBc
Total Harmonic Distortion <0.075% (10 Hz to 20 kHz, 0 dBm)
Spurious (non-harmonic)
Typical (0 dBm)
≤10 MHz: <-70 dBc
>10 MHz: <-70 dBc + 6 dB/octave
Phase Noise
Typical (0 dBm, 10 kHz offset)
10 MHz: <-125 dBc/Hz
Signal Characteristics
Square
Rise/Fall Time
Typical (1 Vpp)
<10ns
Overshoot
Typical (100 kHz, 1 Vpp)
≤5%
Duty Cycle 0.01% to 99.99% (limited by the current frequency setting)
Non-symmetry 1% of the period + 5 ns
Jitter (rms)
Typical (1 Vpp)
≤5 MHz: 2 ppm + 200 ps
> 5 MHz: 200 ps
Ramp
Linearity ≤1% of peak output (typical, 1 kHz, 1 VPP, 100% symmetry)
Symmetry 0% to 100%
Pulse
Pulse Width 16ns to 999.999 982 118ks (limited by the current frequency setting)
Duty Cycle 0.001% to 99.999% (limited by the current frequency setting)
Rising/Falling Edge ≥10 ns (limited by the current frequency setting and pulse width setting)
Overshoot
Typical (1 Vpp)
≤5%
Jitter (rms)
Typical (1 Vpp)
≤5 MHz 2 ppm + 200 ps
> 5 MHz 200 ps
Arbitrary Waveform
Waveform Length
2Mpts (std.)
16Mpts (opt.)
8Mpts (std.)
16Mpts (opt.)
8Mpts (std.)
16Mpts (opt.)
Specications
All the specications can be guaranteed if the following two conditions are met unless where noted.
· The generator is within the calibration period and has performed self-calibration.
· The generator has been working continuously for at least 30 minutes under the specied temperature (18
℃
~ 28
℃
).
All the specications are guaranteed unless those marked with “typical”.
3
RIGOL