User manual

DG1022 Commands System RIGOL
Programming Guide for DG1022
2-53
BURSt
BURSt commands are used for setting the generator to output pulse sequence(called
burst) with specified cycles. Among CH1, burst could be generated based on sine,
square, ramp, pulse or arbitrary waves.
DG1022 supports following BURSt commands:
1. BURSt:MODE
2. BURSt:MODE?
3. BURSt:NCYCles
4. BURSt:NCYCles?
5. BURSt:INTernal:PERiod
6. BURSt:INTernal:PERiod?
7. BURSt:PHASe
8. BURSt:PHASe?
9. BURSt:STATe
10. BURSt:STATe?
11. BURSt:GATE:POLarity
12. BURSt:GATE:POLarity?