User manual

DG1022 Commands System RIGOL
Programming Guide for DG1022
2-41
PM
In PM, the phase of carrier is varies with the instantaneous voltage of the modulation
waveform. Among CH1, the generator can generate PM modulation waves. In addition,
PM commands could be used for these settings: modulation source, modulation
waveform, modulation frequency, phase deviation and PM modulation state.
DG1022 supports following PM commands:
1. PM:SOURce
2. PM:SOURce?
3. PM:INTernal:FUNCtion
4. PM:INTernal:FUNCtion?
5. PM:INTernal:FREQuency
6. PM:INTernal:FREQuency?
7. PM:DEViation
8. PM:DEViation?
9. PM:STATe
10. PM:STATe?