User manual

DG1022 Commands System RIGOL
Programming Guide for DG1022
2-29
Function
Query the edge of “tirgger output”.
Return Value
The query returns POSITIVE or NEGATIVE.
11. OUTPut:TRIGger
Command
Format
OUTPut:TRIGger {OFF|ON}
Function
Disable or enable the [Ext Trig/FSK/Burst] connector on rear panel.
Example
OUTP:TRIG OFF
12. OUTPut:TRIGger?
Command
Format
OUTPut: TRIGger?
Function
Query the state of the [Ext Trig/FSK/Burst] connector on rear
panel.
Return Value
The query returns OFF or ON.
13. OUTPut:CH2
Command
Format
OUTPut:CH2 {OFF|ON}
Function
Disable or enable the front-panel [Output] connector of CH2.
Example
OUTP:CH2 ON
14. OUTPut:CH2?
Command
Format
OUTPut:CH2?
Function
Query the state of front-panel [Output] connector of CH2.
Return Value
The query returns OFF or ON.
15. OUTPut:LOAD:CH2
Command
Format
OUTPut:LOAD:CH2 {<ohm>|INFinity|MINimum|MAXimum}
Function
Select the desired output termination of CH2. The specified value
is only used for amplitude and offset voltage.
Explanations
 Ω is the unit of <ohm>, the default is 50Ω.
 “INFinity” sets the output terminal as “High Z”.
Example
OUTP:LOAD:CH2 MIN
16. OUTPut:LOAD:CH2?