Phau Ntawv Qhia

1. Reference Figure 2.
2. Locate a suitable, “high and dry” location to mount the relay, close to the vehicle battery, in the
engine compartment.
3. When routing wire harness through the vehicle rewall (or any sheetmetal panel), make sure there
are no sharp edges that could damage your harness. Protect the harness from damage by using a
grommet and/or loom and tape.
4. Route the light bar, switch, and battery harnesses through the vehicle to their general locations.
5. Switch should be mounted in cab. Route the switch leads to desired dash location. Mount the
switch. (Drilling + le-tting may be required.) Connect wiring as shown in Figure 3.
6. Connect light bar ying leads to positive and negative harness leads. (RED wire is positive, BLACK
wire is negative.)
7. Connect positive and negative battery terminals to vehicle battery. (RED wire is positive, BLACK
wire is negative.)
8. Test functionality and adjust / aim your lightbar.
9. Tighten mounting hardware to 75 in-lbs. (~6 ft-lbs)
Figure 3
SWITCH WIRING
SWITCH WIRING (SINGLE AND SETS)
- P1- Black Wire
= Switch Ground
- P2 - Blue Wire/Red Wire w/ Heat Shrink
= Switch Output to Relay
- P3 - Red Wire
= Switch Input Power
NOTE: GOLD Spade is the Top of Switch, 3/4” mounting hole required
Black Wire
= Switch Ground
Blue Wire/Red Wire w/ Heat Shrink
= Switch Output to Relay
Red Wire
= Switch Input Power
1
2
3