Phau Ntawv Qhia

RDS SR-SERIES PRO

INSTALLATION INSTRUCTIONS

IMPORTANT

THANK YOU FOR PURCHASING RIGID PRODUCTS FOR YOUR VEHICLE.

Please read through all of these Instructions and tips before proceeding with the installation.

We do our best to provide a simple installation process for all applications however

a professional installation is always recommended.

Always disconnect any power sources connected to your vehicle

before servicing fuses or electrical systems.

PAGE 1
INSTALLATION INSTRUCTIONS RDS SR-SERIES PRO IMPORTANT THANK YOU FOR PURCHASING RIGID PRODUCTS FOR YOUR VEHICLE. Please read through all of these Instructions and tips before proceeding with the installation. We do our best to provide a simple installation process for all applications however a professional installation is always recommended. Always disconnect any power sources connected to your vehicle before servicing fuses or electrical systems.
PAGE 2
RDS SR-SERIES PRO Mounting your light bar: Assemble mounting hardware onto the light bar as shown in Figure 1. (The mount bushings are designed to clip in, holding the bolts in place.) If using the short L-brackets, it is recommended that you mark the location of your mounting holes using the assembly, drill the mounting holes, then mount the light bar in its final location, using hardware of your choice.
PAGE 3
1. Reference Figure 2. 2. Locate a suitable, “high and dry” location to mount the relay, close to the vehicle battery, in the engine compartment. 3. When routing wire harness through the vehicle firewall (or any sheetmetal panel), make sure there are no sharp edges that could damage your harness. Protect the harness from damage by using a grommet and/or loom and tape. 4. Route the light bar, switch, and battery harnesses through the vehicle to their general locations. 5. Switch should be mounted in cab.