Owners manual

SR-Q MOUNTING TEMPLATE
Measurements are in Inches
WHEN PRINTING:
PRINT 100% ACTUAL SIZE
DO NOT SIZE TO FIT
Dr
Dr
il
il
l
l
Ho
Ho
le
le
s
s
t
t
o
o
5/
5/
16
16
”
”
1) Cut out only the dotted areas, including the two outside holes. 2) Ensure your flat surface allows for 3
3/16
”
x 3
3/16
” of depth
.
3) Tape the template, or secure by other means, to your surface. 4) Mark both drill holes and center area of template with marker. 5) Remove your template and double check your markings by placing rubber gasket over area. Adjust accordingly. 6) After complete check is done to ensure proper alignment, remove marked surface material by using pneumatic tools. 7) Remove or file down rough edges and excess trimmings to allow for light to correctly be placed. 8) Place gasket over light so it rests behind the face of the flush mounted light. Insert light into opening. 9) Insert your 2 bolts into light and through your surface, tighten nuts onto bolts evenly to allow for a proper gasket seal. 10) Wire light according to provided instructions.