Owners manual

Battery Eyelets
A - Red to Positive
P1
A
B
C
D
E
B - Black to Negative
SWITCH WIRING
Wiring: Wire your lights according to the instructions included with the light.
Take care to avoid any heat sources and sharp or abrasive surfaces.
NOTE: 3/4” mounting hole required
SWITCH WIRING (SINGLE AND SETS)
- P1-A (Red Wire) on the Harness connect to 2A on the switch
- P1-B (Red & White Wire) on the Harness connect to 3A on the switch
- P1-C (Red Wire with Black Heat Shrink) on the Harness connect to 1A on the switch
- P1-D (Black Wire With Red Stripe) on the Harness connect to 1B on the switch
- P1-E (Black Wire) on the Harness connect to 3B on the switch