Owners manual
WIRING INSTRUCTIONS
Battery Eyelets
Switch
Deutsch Connector
Fuse
1. When routing wire harness through any metal surface be sure it is free of any
sharp edges and protected using wire sheathing or a grommet.
2. Route the harness through vehicle, connect the Rear Facing lamps by directly
plugging into the Deutsch connector’s that are pre-terminated onto the harness.
3. Route the switch lead of the harness to the desired switch location and follow
the wiring diagram to ensure proper connections at the switch.
4. Connect the positive and negative battery terminals once all connections have
been made with the RED harness lead connected to the positive battery terminal
and the BLACK wire to the negative battery terminal.
5. Test to verify functionality, be sure to properly aim your new Rear Facing
lighting before nal torque on all mounting hardware.
6. If connecting to an existing switch be aware of the current rating of your
selected switch, if switch rating is less than the amperage required to power your
lighting then a relay must be added in line to prevent failure of the switch.
7. If connecting to existing wiring, make sure to use appropriate fusing and wire
gauge. Be sure to use heat shrink tubing on all connections to ensure a weather
tight seal.
IMPORTANT
Always disconnect the vehicle battery terminals before servicing the electrical system