Owners manual

F - 5/16” Flat Washer

E - 5/16-18 Carriage Bolt

D - Mounting Bracket

C - M6 Nyloc Nut (1)

B - M6 Allen Socket Head (1)

A - LED Light (Housing)

G - 5/16” Split Washer

H - 5/16-18 Nut

REAR FACING SR-Q SERIES

Assemble your LED light kit by attaching the mount (D) to the housing (A) using the provided bolt(s)

(B) and nylon lock nut(s) (C). Tighten until snug. Use the remaining bolt, washers, and nut (E, F, G, H) to

mount the completed light assembly. A 5/16” hole is required. (See Figure Below)

REAR FACING SR-M SERIES

Assemble your LED light kit by attaching the mount (D) to the housing (A) using the provided bolt(s)

(B) and nylon lock nut(s) (C). Tighten until snug. Use the remaining bolt, washers, and nut (E, F, G, H) to

mount the completed light assembly. A 5/16” hole is required. (See Figure Below)

REAR FACING D-SERIES

Assemble your LED light kit by attaching the mount (D) to the housing (A) using the provided bolt(s)

(B) and nylon lock nut(s) (C). Tighten until snug. Use the remaining bolt, washers, and nut (E, F, G, H) to

mount the completed light assembly. A 5/16” hole is required. (See Figure Below)

C - M6 Nyloc Nut (1)

B - M6 Allen Socket Head (1)