Owners manual

1. 1/4” Flat Washer
2. 1/4 - 20 Nut
3. 1/4” Isolation Washer
4. 1/4 - 20 x 3/4 Button
Socket Bolt
5. 1/4” Lock Washer
6. Flushmount Gasket
WIRING LEADS
WIRING
WIRING INSTRUCTIONS
1. Always disconnect the negative battery terminal from the vehicle when working
with any electrical circuits.
2. If connecting to existing wiring, make sure to use appropriate fusing and wire
gauge. Be sure to use heat shrink tubing on all connections to ensure a weather
tight seal.
3. Be aware of the current rating of your selected switch, if switch rating is less than
the amperage required to power your lighting then a relay must be added in
line to prevent failure of the switch.
4. When routing wiring through any metal surface be sure the surface is free of
any sharp edges and protected by using wire sheathing.
5. Follow the wiring image above to ensure you have the correct wire color for the
separate back-lighting and projecting LED circuits.
6. Re-connect the negative battery terminal and fully tighten all mounting
hardware. Test to verify functionality and beam angle.
RED WIRE (+12V DC ) = PROJECTING TRIGGER
BLACK WIRE = GROUND
WHITE WIRE (+12V DC) = BACK-LIGHTING TRIGGER
Radiance Pod
Scene Beam
Pattern
Up to 100˚
Radiance
Pod Beam
Pattern
Part # 40300
Radiance Pod / Pod Scene
Harness Comes Complete with:
(2) Switches, (1) In-Line Fuse,
(2) Output Leads, and Battery Leads.
*Sold Seperately