Owners manual

1. 1/4” Flat Washer

2. 1/4 - 20 Nut

3. 1/4” Isolation Washer

4. 1/4 - 20 x 3/4 Button

Socket Bolt

5. 1/4” Lock Washer

6. Flushmount Gasket

FLUSH MOUNT

RADIANCE POD MOUNTING TEMPLATE

Measurements are in Inches

WHEN PRINTING: PRINT 100% ACTUAL SIZE

DO NOT SIZE TO FIT

1) Cut out only the dotted areas, including the two outside holes.

2) Ensure your ﬂat surface allows for 3

3/16

”

x 3

3/16

” of depth

3) Tape the template, or secure by other means, to your surface.

4) Mark both drill holes and center area of template with marker.

5) Remove your template and double check your markings by placing

rubber gasket over area. Adjust accordingly.

6) After complete check is done to ensure proper alignment, remove

marked surface material by using pneumatic tools.

7) Remove or ﬁle down rough edges and excess trimmings to allow for

light to correctly be placed.

8) Place gasket over light so it rests behind the face of the ﬂush

mounted light. Insert light into opening.

9) Insert your 4 bolts into light and through your surface, tighten nuts

onto bolts evenly to allow for a proper gasket seal.

10) Wire light according to provided instructions.

”