Owners manual

ManualsBrandsRigid Industries ManualsAutomotive68213 Radiance Scene Backlight

POD / POD SCENE INSTALLATION INSTRUCTIONS

*Angled

View

IMPORTANT

1. Radiance lights are designed to operate from 10V DC - 15 VDC only. Using this product

on a 24V DC or higher system will cause permanent damage to electrical components.

2. Colored back-lighting and projecting LED’s are intended for off-road use only.

Consult your local, state and federal laws, rules and regulations to determine whether your

particular application/installation is authorized for use on a public highway.

A M6 Nylock Nut

B M6-1x20 Socket Head

C Mounting Bracket can be

reveersed for additional

mounting options

D 5/16-18x1 Carriage Bolt

E 5/16 Flat Washer

F 5/16 Lock Washer

G 5/16-18 Nut

SURFACE

MOUNT

Summary of content (4 pages)

PAGE 1
POD / POD SCENE INSTALLATION INSTRUCTIONS *Angled View IMPORTANT 1. Radiance lights are designed to operate from 10V DC - 15 VDC only. Using this product on a 24V DC or higher system will cause permanent damage to electrical components. 2. Colored back-lighting and projecting LED’s are intended for off-road use only. Consult your local, state and federal laws, rules and regulations to determine whether your particular application/installation is authorized for use on a public highway.
PAGE 2
FLUSH MOUNT 1. 1/4” Flat Washer 2. 1/4 - 20 Nut 3. 1/4” Isolation Washer 4. 1/4 - 20 x 3/4 Button Socket Bolt 5. 1/4” Lock Washer 6. Flushmount Gasket RADIANCE POD MOUNTING TEMPLATE Measurements are in Inches WHEN PRINTING: PRINT 100% ACTUAL SIZE DO NOT SIZE TO FIT Dr ill Holes to 5/ 16 ” 1) Cut out only the dotted areas, including the two outside holes. 2) Ensure your flat surface allows for 3 3/16” x 3 3/16” of depth. 3) Tape the template, or secure by other means, to your surface.
PAGE 3
WIRING WIRING LEADS RED WIRE (+12V DC ) = PROJECTING TRIGGER BLACK WIRE = GROUND WHITE WIRE (+12V DC) = BACK-LIGHTING TRIGGER WIRING INSTRUCTIONS 1. Always disconnect the negative battery terminal from the vehicle when working with any electrical circuits. 2. If connecting to existing wiring, make sure to use appropriate fusing and wire gauge. Be sure to use heat shrink tubing on all connections to ensure a weather tight seal. 3.
PAGE 4
Warranty Information For warranty information visit www.rigidindustries.com/about/warranty 779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337 ext 1008 • www.rigidindustries.com Rigid Industries and Rigid Industries Radiance are registered and/or common law marks owned by JST Performance, LLC d/b/a Rigid Industries.