Owners manual

STEP 3
Install the RIGID bracket as shown
while pulling the front plastic away
from the SXS. The bracket installs
between the shock mount and plastic
radiator mount.
See Figure 3
STEP 4
Once the RIGID bracket and light is in place, reinstall the rear plastic using the (5) factory bolts. Adjust
lights as needed. Once done with nal adjustments, you have nished the installation.
WARRANTY INFORMATION
For warranty information, visit www.rigidindustries.com/about/warranty
779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337
www.rigidindustries.com
SR-M Series PRO, RIGID and Rigid Industries are registered and/or common law marks owned by JST Performance, LLC,
a Delaware limited liability company d/b/a Rigid Industries.
11-12460-A
Wiring: Wire your lights according to the instructions included with the light.
Take care to avoid any heat sources and sharp or abrasive surfaces.
Your installation is now complete.
Welcome to the Rigid Nation!
FIGURE 2
FIGURE 3
STEP 2
Mount the lights as shown below
using the provided hardware that
came with the lights. Make sure
the light bracket itself is tight, once
installed on the plastic, you will have
to adjust and aim them properly.
See Figure 2