Owners manual

FIGURE 7
STEP 7
Install the RIGID D-Series onto the
bracket as shown by laying them on
a at surface, while pressing down
on the lights and bracket, tighten
the nuts from the back side. Once
installed, use the provided hardware
and install it from the inner fender
well. Using a ½” wrench, tighten the
nuts as shown below.
See Figures 7, 7.1, 7.2
FIGURE 7.1
FIGURE 7.2
STEP 8
Once lights are installed on the
bracket, run the harnesses through
the bracket as shown.
See Figure 8
FIGURE 8