Owners manual

Wiring Instructions For Factory Upfitter Switches:

**Always disconnect battery before servicing any fuses or electrical system**

The following instructions are for installation & wiring for 2011 Ford Super Duty equipped with OEM

Upfitter switches.

*If your vehicle was not equipped from the factory with the Upfitter switches, they can be purchased

through your local Ford dealer along with the associated wiring harness.

**A universal wiring harness is included that can be modified for trucks without Upfitter switches.

Step 1

Identify Upfitter wiring harness, located near driver’s side kick panel, above emergency brake pedal.

This is where you will obtain power for the 20” E-Series lightbar

Switch 1 – Yellow (20A fused) – Recommended location for 20” E Series Rigid Lightbar

Switch 2 – Green with Brown Stripe (20A fused)

Switch 3 – Violet with Green Stripe (10A fused)

Switch 4 – Brown (15A fused)

2011 & 2012 Ford Super Duty

20” E-Series/SR Series

Installation Instructions

PAGE 1
2011 & 2012 Ford Super Duty 20” E-Series/SR Series Installation Instructions Wiring Instructions For Factory Upfitter Switches: **Always disconnect battery before servicing any fuses or electrical system** The following instructions are for installation & wiring for 2011 Ford Super Duty equipped with OEM Upfitter switches. *If your vehicle was not equipped from the factory with the Upfitter switches, they can be purchased through your local Ford dealer along with the associated wiring harness.
PAGE 2
PAGE 3
PAGE 4
Congratulations! Your new lightbar is now ready for duty. Contact for Technical Questions 480-655-0100 Email Technical Questions info@rigidindustries.