Owners manual

ADAPT | 17
3. The Black Wire from the GPS module will share pin 3 connector C on the Adapt under dash module. This will provide
chassis ground to the GPS unit.
4. The violet wire from the GPS module will go directly into pin 3 connector A on the Adapt under dash module. This will
provide the GPS signal to the Adapt unit.
OPERATION
1. Once the GPS unit is mounted and all wiring is connected properly, you are ready to test the unit.
2. Turn vehicle on. This will provide power to the GPS and Adapt system.
3. It can take up to 2 minutes for the GPS to find a satellite before the unit will provide a signal to the Adapt under
dash module.
4. Activate the Adaptive mode by pressing the Adapt Icon on the Adapt dash controller. Adaptive mode will default to
Mode 1.
5. The Adapt mode is user adjustable so you can calibrate the top intended speed. To calibrate the Adapt Mode, safely
drive at the top speed where spot mode will be desirable. While remaining at this speed,
press and hold the Adaptive
Mode button on the Adapt dash controller until the Adapt Mode button icon flashes red. This indicates that the top
speed was saved.
6. The Adapt system will now operate in mode 8 based on the top speed selected and automatically step down
incrementally from mode 8 to mode 1 as your vehicle speed is reduced. Simply turn off the Adapt mode by pressing
the Adapt icon on the Adapt dash controller.
GPS MODULE OPERATION (SOLD SEPARATELY)