Owners manual

ADAPT | 16
This GPS module is required for the Adaptive Mode feature in the RIGID Adapt light bar. Once this unit is installed, the RIGID
Adapt will use the GPS signal to automatically change modes based on vehicle speed.
MOUNTING
1. Find the desired location to mount the GPS interface module that is protected against heat and water submersion.
2. The mounting orientation is not critical to the function of the unit so it can be easily mounted on a vertical or
horizontal surface using mounting screws, zip ties, or tape.
CABLE ROUTING
1. The GPS antenna has a magnetic base, so it will securely hold in place on any metal surface.
2. The GPS antenna needs to have line of site to the Satellite’s in the sky. It is recommended to be placed on the roof
of the vehicle.
3. When routing wire cable through any metal surface, be sure it is free of any sharp edges and protected using wire
sheathing or a grommet.
WIRING - REFER TO PAGE 15
1. Connect the GPS antenna to the interface module by screwing the SMA connector on the antenna cable to the
mating connector on the module. Be careful not to over torque this connection if using a wrench.
2. The red wire from the GPS module will share pin 4 on connector A on the Adapt under dash module. This wire will
provide ignition power to the GPS unit.
GPS MODULE OPERATION (SOLD SEPARATELY)