Installation Instructions

CAUTION: DO NOT ATTACH ADDITIONAL
STRAPS TO THE WEBBING LOOPS ON THE TARP;
DAMAGE MAY RESULT. THE WEBBING LOOPS
FUNCTION AS GUIDES FOR THE BUNGEES, NOT
AS ATTACHMENT POINTS FOR ADDITIONAL
STRAPS.
8-After use, dry off the Truck Bed Cargo Net with Built-In
Tarp, fold it down (Fig 19), and store it in its stuff sack (Fig
20 ).
5-Attach the hooks as needed to the trailer’s frame (Fig
14), to the load (Fig 15), or to the trailer’s ramp (Fig 16).
6-Slide the cross bungees along the outer bungee loop
until they are best positioned to securely hold the load
(Fig 17); the bungees are able to independently stretch in
each direction.
Fig 18
Fig 15 Fig 16
1 Year Manufacturer’s Limited Warranty
www.rightlinegear.com/product-warranty.html
Fig 17
Fig 13 Fig 14
4-Tuck the tarp under the bottom edge of the cargo if
desired (Fig 13).
Fig 12
1-Pack the trailer evenly in height if possible. Make sure
there are no sharp-edged objects pointing outward.
Set Up On A Utility Trailer
2-Lay the tarp on the ground with the Fox Logo facing
away from the rear of the trailer.
3-Pull the tarp over the trailer towards the vehicle (Fig 12).
7-If the net is too loose, relocate the hooks to the orange
bungees in order to increase the tension of the net (Fig 18).
CAUTION: IF THE LOAD IS EXTREMELY HEAVY
OR EXTENDS ABOVE THE TRAILER’S SIDE RAILS,
THE ADDITION OF RATCHET TYPE STRAPS UN-
DER THE TRUCK BED CARGO NET WITH BUILT-IN
TARP MAY BE NECESSARY TO HOLD THE LOAD
SECURELY IN PLACE.
Fig 19
Fig 20