Use and Care Manual

ATTENTION! When using a foundation frame assemble in advance on this soil profi le (see page 5, 6)
glazing
rand rung right - curved (pos.1.5.6)
rand rung left - curved (pos.1.5.4)
rand rung to the corner connection peg plugged
The rear gable is assembled in the same way!!!
glazing
Only rear gable!
connecting
plate (V10)
crossbar
(Pos.1.8)
step 5 to step 5:
The square peg of the corner con-
nector is plugged in the rand rung
(pos.1.5.4/1.5.6).
Small triangular glazing positioned
on the door frame (pos.1.8).
The rand rung by means of
connecting plate (V5) screwed to
the door frame. On the rand rung
you need 2 self-tapping screws pan
head 4,2 x 13 (S9), on the door
frame 2 hexagonal screws M6 x 16
(S5).
- See also step 4! -
step 6:
to step 6:
The crossbars (pos.1.9) are
mounted sideways with the self-
tapping screw pan head 4,8 x 45
(S13).
step 7:
view from outside
to step 7:
Slide before mounting the crossbar
required hex screws M6 x 16 (S5)
into the profi le of the crossbar
(pos.1.8 und 1.9).
The crossbar in the rear gable
is used the same height as the
existing crossbar. Attachment is to
the connecting plate (V10).
Now comes the glazing
(787 x 728 mm).
The remaining opening is later
closed by the supplied rear window.
Assembly procedure gable
view from inside
holes for
door lock
11