Product Manual

Possible Problems and resolutions
SpO
2
or PR
can not be
shown normally
Problems Possible reason Solution
SpO
2
or PR is
shown unstably
The Oximeter
can not be
powered on
Indication
lamps are
suddenly off
“Error3”or
“Error4” is
displayed on
screen.
1.Finger is not plugged correctly
2.Patient’s Oxyhemoglobin value is
too low to be measured.
1.Finger might not be plugged
deeply enough.
2.Finger is trembling or patient’s
body is in movement status.
1.Power of batteries might be
inadequate or not be there at all.
2.Batteries might be installed
incorrectly.
3.The Oximeter might be damaged.
1.The product is automatically
powered off when no signal is
detected longer than 8 seconds
2. Lower power
1.Low power
2.Mechanical malfunction for
receive-emission tube
3. Amp circuit malfunction.
1. Retry by plugging the nger.
2. Try some more times, If you
can make sure about no problem
existing in the product. Please go
to a hospital for exact diagnosis.
1.Retry by plugging the nger.
2.Try not to move.
1.Please replace batteries
2.Please reinstall the batteries
3.Please contact with local customer
service centre.
1.Normal
2.Replace the batteries
1.Change batteries.
2.Please contact the local customer
service center.
3.Please contact the local customer
service center.
- 10 -