User manual

270416 3
SAFE L.2
A1, A2
13-14, 23-24, 33-34
Y1-Y2
S12, S22
BR1-BR2
Aufbau und Funktionsweise
(Block Diagramm)
Anschluss Betriebsspannung
Sicherheitsstrompfade (Schließer)
Starttaster
Eingänge für die BWS - Ausgänge
Drahtbrücke zwischen BR1 und BR2
ermöglicht automatischen Start
Vor dem Betreiben des Gerätes muss die
Variante mit und ohne Überwachung des
Starttasters festgelegt werden. Mit Brü-
cke BR1 - BR2 und Y1 - Y2 wird die Va-
riante ohne Überwachung der Starttaste
realisiert.
Für das Betreiben des Gerätes muss
eine Versorgungsspannung an die
Klemmen A1 und A2 angelegt werden.
Die LED `Netz` und `Wiederanlaufsperre`
leuchten. An der Klemme S11 steht dann
eine Spannung von 24 V DC zur Verfü-
gung.
S12 und S22 werden nach den entspre-
chenden Anwendungsbeispielen be-
schaltet.
Zum START des Gerätes muss die
Klemme Y1 mit Y2 über einen Schließer-
kontakt überbrückt werden.
Danach sind die Kontakte 13-14, 23-24
und 33-34 geschlossen. Die LED´s Kanal
1 und Kanal 2 leuchten, die LED `Wie-
deranlaufsperre` erlischt.
In Reihe zu dem START-Taster an den
Klemmen Y1 und Y2 kann die Schaltung
eines externen Schützes überwacht wer-
den (siehe Anwendungsbeispiel 3).
Assembly and function
(block diagram)
connection operation voltage
safety circuits (normally open)
start button
inputs for the ESPE outputs
With bridging BR1 and BR2
automatic activation is possible.
Before using the device, it must be de-
cided whether version with or without
monitoring the start button should be
used. The version without start control
needs bridges between BR1 - BR2 and
Y1 - Y2.
A supply voltage must be applied at the
terminals A1 and A2 in order to operate
the device. Both LED’s, “Power” and
“Interlock” illuminating. A voltage of 24V
DC is available at Terminal S11.
Terminals S12 and S22 must be con-
nected according to the application ex-
ample.
To START the unit, terminal Y1 and Y2
must be bridged with a normally open
contact. The unit works if you close this
contact.
Thereafter the contacts 13-14, 23-24 and
33-34 are closed. The LED’s Power,
channel 1 and channel 2 illuminates. The
Interlock LED does not illuminate.
In series to the START-button an exter-
nal contactor can be monitored (see ap-
plication 3).
Überwachungslogik /
control logic
K2
K1
elektr.
Sicherung /
electr. fuse
A1
S12
(+)
BR1S11 BR2
S22
Y1
Y2
2313 33
K2
K1
(-)
A2
~
~
=
+
-
~
~
2414 34