Operation Manual

51
Placing the chain on sprocket and inserting
rear wheel
• Push the rear derailleur backwards and put
the chain on the smallest sprocket
• Insert the rear wheel into the rear drop outs.
Mounting brake arm
• Mount the coaster brake arm and tighten
the bolt with a torque of 6 Nm.
Tightening wheel
• Put all washers and tabbed xing washers
in correct position onto the axle.
• Tighten axle nuts or quick-release (for
torque settings see page 62).
Checking the brake
• Re-hook the brake cable in position or
tighten it again.
• Check if the adjustment of the brake pads is
still correct.
• Check that after the repair the braking
surfaces are still free from grease or other
lubricants.
Rohlo Hub
• Mount the shifter cables (see Rohlo
manual).
Birdy touring with Dual Drive Hub
• Insert the thread rod into the plastic hous-
ing when the axle nuts are tightened. The
shifter cable should be slightly tight in first
gear.
ATTENTION!
Take care of correct position of all
washers. Incorrect positioning will
lead to malfunction.
Incorrect assembly can lead to
poor functioning or failure of the
brakes. Proceed in strict accord-
ance with the manufacturer’s
instructions. You absolutely
must test your brakes! Errors in
mounting wheels can lead to loss
of control, and could lead to seri-
ous accidents. Incorrect position-
ing will lead to malfunction.
DANGER!
• Tightening torque of the axle nuts: 30Nm.
• Tighten axle nuts or quick-release (for
torque settings see page 62).