Operation Manual

25
HOW TO ADJUST THE AXIAL PLAY
If there is too much play first check if the
right bolt M 4x10 is suciently tightened.
• To reduce the play, rst loosen both bolts
M4x16. Slightly tighten the left bolt M4x10.
Watch for correct fit of the cap.
• Tighten both bolts M4x16 again (torque set-
ting 2-3 Nm).
• If the lever becomes sti, there is too little
play. Loosen both bolts M 4x16 and then
bolt M 4x10.
• Loosen the lever and tighten both bolts
M4x16 again (torque setting 2–3 Nm).
• Tighten left bolt M 4x10 (torque setting
1 Nm).
HOW TO ADJUST THE ACTION POINT
The point of maximum clamping force should
be reached shortly before the end position.
Otherwise it has to be adjusted.
• Open the left bolt M 4x10 for a half rotation.
• Loosen one of the M 4x16 bolts and tighten
the other one (see arrows in picture). The
white arrows show how to achieve an
earlier action point.
• After correct adjustment of the action point
please tighten both bolts M 4x16.
• Check again for correct tightening force.
ATTENTION!
Always tighten the left bolt M 4x10
after tightening both bolts M 4x16.
Otherwise the axial play can
change!