Technical data
Table Of Contents
- DESCRIPTION
- INSTALLATION
- CONFIGURATION
- Overview
- Configuration via SSH or USB: menu description
- Start menu
- Setup menu
- IP config menu
- Time setting menu
- Scheduled NTP menu
- UPS config menu
- Services 1 menu
- SNMPv1 config menu
- SNMPv1 community menu
- Email config menu
- Email logic menu
- Miscellaneous menu
- Activation 1 menu
- Services 2 menu
- Wake-On-LAN address menu
- Wake-On-LAN delay menu
- Activation 2 menu
- Sensors Config menu
- I/O Sensors menu
- Security menu
- Save and load menu
- Expert mode
- Configuration of several devices
- FIRMWARE UPGRADE
- SNMPV3 CONFIGURATION
- MODBUS TCP/IP PROTOCOL
- TECHNICAL DATA
- 26 -
Activation 1 menu
/------------------------/
/ Activation 1 /
/------------------------/
Enable SSH.....:[ON/off]<-- Enable FTP.....:[ON/off]
Enable HTTP....:[ON/off] Enable DataLog.:[ON/off]
Enable SNMP....:[ON/off] Enable Email...:[on/OFF]
Enable UDP.....:[ON/off] Enable Report..:[on/OFF]
With this menu the services implemented in NetMan 204 can be activated or deactivated:
Use the ENTER key to change the selected configuration (“ON” or “OFF”).
• ON (green characters): service active
• OFF (red characters): service not active
It is recommended to activate only the services used.
Services 2 menu
/------------------------/
/ Services 2 /
/------------------------/
WakeOnLan addr.:<--
WakeOnLan delay:
Activation.2...:
Sensors config :
I/O Sensors....:
Threshold sens.:
With this menu the configuration screens of the various services can be accessed as described in
the following table.
Menù Funzione
WakeOnLan addr.
To configure the Wake-on-LAN service
WakeOnLan delay
Activation 2 To configure the services to be activated
Sensors. config
To configure the environmental sensors
I/O Sensors
Threshold sens
As well as being configured, the services must also be activated to function correctly (see
paragraph “Activation 2 menu”). It is recommended to activate only the services used.