Operator`s manual

ManualsBrandsRIDGID ManualsPower ToolsTS3612

OPERATOR’S MANUAL

ZERO CLEARANCE INSERT

AC1035

For Use With Table Saws TS2400

(TS2400-0), TS2412, TS2424, and TS3612

SAVE THIS MANUAL FOR FUTURE REFERENCE

Your zero clearance insert has been engineered and manufactured to our high standard for dependability, ease of operation,

and operator safety. When properly cared for, it will give you years of rugged, trouble-free performance.

WARNING:

To reduce the risk of injury, the user must read and understand the operator’s manual before using this product.

Thank you for buying a RIDGID product.

Summary of content (6 pages)

PAGE 1
OPERATOR’S MANUAL ZERO CLEARANCE INSERT AC1035 For Use With Table Saws TS2400 (TS2400-0), TS2412, TS2424, and TS3612 Your zero clearance insert has been engineered and manufactured to our high standard for dependability, ease of operation, and operator safety. When properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual before using this product. Thank you for buying a RIDGID product.
PAGE 2
RULES FOR SAFE OPERATION n ALWAYS DISCONNECT THE SAW FROM THE POWER SUPPLY BEFORE ASSEMBLING THIS KIT. Make sure this switch is off when reconnecting the saw to a power supply. WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. n MAKE SURE THE SAW BLADE OR DADO BLADE IS NOT IN CONTACT WITH THE INSERT BEFORE TURING THE SAW “ON.
PAGE 3
ASSEMBLY INSERT WARNING: Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious personal injury. WARNING: FLAT HEAD SCREW Never stand directly in line with the blade or allow hands to come closer than 3 in. to the blade. Do not reach over or across the blade. Failure to heed this warning can result in serious personal injury. Fig. 1 WARNING: The zero clearance insert must be even with the table surface.
PAGE 4
ASSEMBLY PREPARING THE INSERT FOR THROUGH CUTS PREPARING ZERO CLEARANCE INSERT FOR NON-THROUGH CUTS n Make sure the blade guard is properly installed and adjusted. n Make sure the blade guard is properly installed and adjusted. n Lower the blade completely. n Lower the blade completely. n Check all clearances for free blade rotation. n Check all clearances for free blade or dado rotation. n Plug in the saw. n Plug in the saw. n Turn on the saw and cautiously raise the saw blade into the insert.
PAGE 5
NOTES 5
PAGE 6
OPERATOR’S MANUAL ZERO CLEARANCE INSERT AC1035 For Use With Table Saws TS2400 (TS2400-0), TS2412, TS2424, and TS3612 Customer Service Information: For parts or service, contact your nearest RIDGID authorized service center. Be sure to provide all relevant information when you call or visit. For the location of the authorized service center nearest you, please call 1-866-539-1710 or visit us online at www.ridgid.com. When ordering repair parts, always give the following information: AC1035 Model No.