Specifications

17
3. Hold the hinge plate with the caster in the center of the
frame as shown. Slide the 5/16-18 x 4-1/4 bolt through
frame and hinge plate. Finger tighten lock nut. Tighten
nut with a 1/2" and adjustable wrench but do not over
tighten. The hinge plate should freely pivot inside the
frame.
NOTE: The hinge plate can be mounted in either set of
holes as shown.
4. From the bag labeled "Caster" remove the following
hardware:
1 Hex Head Screw, 1/4-20 x 3/4" Long
1 Lockwasher, 1/4" External Type
1 Hex Nut, 1/4-20
5. From the caster carton find the following:
1 Handle
6. Slide handle all the way down, over actuator and fasten
using 1/4-20 x 3/4 hex head screw, lockwasher and nut
as shown. Tighten nut securely using a 7/16" and
adjustable wrench, compressing handle over stem.
Swivel Caster Adjustment
1. Rotate handle so that stem is fully extended inside
center frame. Using fingers adjust button head cap
screw so that the caster is aligned parallel with the bot-
tom of the center frame as illustrated. Tighten nut
securely against stem.
NOTE: If actuator loosens, tighten using an adjustable
wrench on sides of actuator as shown.
5/16-18 x 4-1/4
Bolt
5/16-18
Lock Nut
Alternate
Mounting
Location
1/4-20
1/4-20 Nut
1/4 Lockwasher
Actuator
Handle
Screw
Rotate Handle Extending
Stem Inside Frame
Tighten Nut
Against
Caster Pivots
Up Inside
Frame When
Stem
Stem Is
Released
Align Edges
as Shown
Handle
Parallel
Tighten with
Adjustable Wrench
If Necessary
Hex Hd. Bolt
1/4-20 x 3/4"
Ext Lockwasher
1/4"
Hex Nut
1/4-20