Operator`s manual

CS6 – English – 7
Pre-Operation Inspection
WARNING
To reduce the risk of serious injury from electrical
shock or other causes, and to prevent damage to
your equipment, inspect all equipment and correct
any problems before each use.
To inspect all equipment, follow these steps:
1. Power off your equipment.
2. Disconnect and inspect all cords, cables, and con-
nectors for damage or modification.
3. Clean any dirt, oil, or other contamination from your
equipment to ease inspection and to prevent it from
slipping from your grip during transportation or use.
4. Inspect your equipment for any broken, worn, miss-
ing, misaligned, or binding parts, or any other con-
dition which might prevent safe, normal operation.
5. Refer to the instructions for all other equipment to
inspect and make sure it is in good, usable condi-
tion.
6. Check your work area for the following:
• Adequate lighting.
• The presence of flammable liquids, vapors, or
dust that may ignite. If present, do not work in
area until sources have been identified and cor-
rected. The equipment is not explosion proof.
Electrical connections can cause sparks.
• A clear, level, stable, and dry place for the oper-
ator. Do not use the equipment while standing
in water.
7. Examine the job to be done and determine the cor-
rect equipment for the task.
8. Observe the work area and erect barriers as neces-
sary to keep bystanders away.
Specic Safety Information
WARNING
This section contains important safety information
that is specific to the SeeSnake CS6. Read these pre-
cautions carefully before using the CS6 to reduce
the risk of electrical shock, fire, and/or serious injury.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE!
SeeSnake CS6 Safety
• Read and understand this manual, the camera reel
manual, and the instructions for any other equip-
ment you are using before operating the equip-
ment. Failure to follow all instructions may result in
property damage and/or serious injury. Keep this man-
ual with the equipment for future use.
• Operating the equipment while in water increases
the risk of electrical shock. Do not operate the CS6
if the operator or equipment are standing in water.
• The CS6’s battery and other electrical equipment
and connections are not waterproof. Do not expose
the equipment to wet locations.
• The CS6 is not designed to provide high voltage
protection and isolation. Do not use where a danger
of high voltage contact is present.
• Only power the CS6 with a compatible battery or a
double insulated AC adapter. The AC adapter is in-
tended for indoor use only. When powered by a battery,
protect the CS6 from exposure to weather.
• Do not expose the CS6 to mechanical shocks. Ex-
posure to mechanical shocks can damage equipment
and increases the risk of serious injury.