Operator`s manual

CS6 – English – 31
Troubleshooting
Problem Probable Fault Solution
System does not power
on
Power source
Verify that the battery is a compatible model. Not all
batteries that fit into the battery shoe are compatible.
Recharge the battery.
Switch to AC power.
Unable to capture media No USB drive inserted
Insert a USB drive. A USB drive must be inserted to
capture media.
Verify the USB drive you are using is working and not
corrupted or read-only.
No audio during playback
Speakers are muted
Verify the LED below the Microphone Mute key is lit
and the icon is yellow .
Settings need adjustment
Go to the settings tab to adjust the speaker volume
and microphone gain settings.
Broken file warning
appears after inserting the
USB drive
USB drive was removed
before data was fully written,
files may be corrupted
Select the repair option when prompted to attempt a
file recovery.
Job Manager is empty No USB drive inserted
Insert a USB drive. Job data is stored on the USB
drive only. The CS6 does not have internal memory.
The display is dark or
hard to see
Glare on the display Position the display facing away from direct sunlight.
LCD settings
Go to the LCD settings tab to adjust the LCD display
settings.
Camera LED settings
Press the LED Brightness key to adjust the camera
LED brightness.
Low battery warning
appears
Low battery
Power off to avoid data loss. Recharge the battery or
switch to AC power.
Count measurement
accuracy is unreliable
The drum’s integrated counter
settings are incorrect for the
drum or push cable
Verify the settings are correct for the cable length,
cable diameter, and drum.
Counting from the wrong zero
point
Confirm measurement starts from the intended zero
point.
No live view
No power
Check to make sure the battery is charged or the AC
adapter is properly connected.
Slip-ring assembly is broken
or there is a faulty connection
Check all alignment and connection pins.
Check placement and pin condition in the slip-ring
assembly.
System cable connection is
faulty
Check system cable connection. Make sure the
connector is pushed all the way in and the outer
locking sleeve is secure.