Operator`s manual
CS6 – English – 19
3. Reposition the text wherever you want it on the
screen by highlighting and selecting the move icon
. Use the Arrow keys to move the text box and
press the Select key to save the placement.
4. Highlight the save icon and press the Select key
to superimpose the text onto the video image
and exit back to live view.
Delete or Edit Custom Overlay
To delete or edit existing overlay text, press the Text key
, highlight either Yes, delete or No, edit, and press the
Select key .
Locating the Sonde
Many SeeSnake camera reels have an integrated sonde
which you can use to locate a point of interest in the
pipe. The sonde is located in the spring and is assem-
bled between the end of the push cable and the camera.
The sonde transmits a locatable 512Hz signal that can
be detected by receivers such as the RIDGID SeekTech
SR-20, SR-24, SR-60, Scout
™
, or NaviTrack
®
II.
Press the Sonde key to enable or disable the sonde.
When the sonde is enabled, the LED by the keyis lit and
the sonde icon is displayed. The 512Hz sonde signal
can cause interference lines that may be visible on cap-
tured media.
To locate the sonde, follow these steps:
1. Power on the receiver and set it to sonde mode.
2. Locate the sonde’s general direction so you know
which way the pipe goes:
• Enable the sonde and push the push cable no
more than 5 m [15 ft] into the pipe.
• Sweep the horizon with the receiver in a slow
arc.
3. The signal strength is highest where the receiver
detects the sonde.
Note: For additional instructions on sonde locating, refer
to the manual for the receiver model you are using.