Operator`s manual

16 – English – CS6
Capturing Media
The CS6 does not have internal storage. A USB drive
with available space must be inserted to capture media
and create reports. Media automatically saves to the
open job as it is captured, continuously throughout the
inspection. Each job then generates a report which in-
cludes captured media, company and customer informa-
tion, and notes.
A USB drive is not necessary for basic inspections, in-
cluding live view, operating the sonde, setting zero
points, or controlling the camera brightness.
Interface Icons
A USB drive is inserted. The bar below the
USB drive indicates the remaining capacity
on the USB drive.
Captured media is actively being written
to the USB drive. The percentage shown
represents how much of the captured
media has been written. In this example, 99
percent of the captures have been saved
to the USB drive. Do not remove the USB
drive.
Captured media is being processed and
saved to the USB drive. Do not remove the
USB drive.
Processing is complete and all the media
has been saved. It is safe to remove the
USB drive.
A job is open.
The live view image is flipped.
NOTICE
Premature removal of the USB drive may
result in data loss and corruption.
Reviewing Recent Captures
Press the Review key to view the most recent capture.
Use this key to easily playback a video or Autolog video
recording. From the job review screen you can review all
the captured media in the open job and access the re-
port preview. Press the Menu key to exit and return to
live view.
Taking Photos
Press the Photo key to take a photo. The photo icon
displays briefly and the photo is automatically saved onto
the USB drive in the open job.
Recording Autolog Video
Press the Autolog key to start and stop recording
Autolog video. When Autolog video is recording, the LED
below the key is lit and a red Autolog video icon is dis-
played.
Pause the Autolog video recording by pressing the Se-
lect key . When the Autolog video recording is paused
the red Autolog video icon changes to a black Autolog
video pause icon . Resume Autolog video recording by
pressing the Select key again.
To stop an Autolog video recording, press the Autolog
key . The black Autolog video icon indicates that
the Autolog video recording is stopping and processing.
Wait for a moment while the recording is processed and
saved to the open job. The check mark means the re-
cording has been successfully processed and saved to
the USB drive.
Use Autolog video recording to quick-start an inspec-
tion. When the system is off, press the Autolog key
to power on and automatically begin recording Autolog
video. When prompted, choose Create new job or Ap-
pend to most recent job.
Note: You cannot power off the system by pressing the
Autolog key .