Operator`s manual

CS6 – English – 15
Integrated Counter
All SeeSnake Max camera reels and many original
SeeSnake camera reels come equipped with an inte-
grated counter. The integrated counter measures the
total length of the extended push cable, or system mea-
surement.
The integrated counter can also be used to measure a
segment from a temporary zero point, such as a pipe
head or joint, while still keeping track of the system mea-
surement.
System Measurement
Set the system starting zero point wherever you want
your inspection measurement to begin. This may be at
the pipe entrance or it may be farther down the line.
Press and hold the Zero key for three seconds to
set the system measurement to zero.
Temporary Segment Measurement
To measure a temporary segment distance during an in-
spection, press the Zero key to set a temporary zero
point. The temporary zero point is indicated with brack-
ets. To clear the temporary segment measurement and
return to the system measurement, press the Zero key
again.
Measurement Display
The system measurement is displayed in the bottom left
corner of the screen. A temporary segment measure-
ment is represented by brackets.
Inspection start point. System
measurement is set to zero.
Distance from system zero start point.
Temporary segment measurement
start point.
Distance from temporary zero start
point.
Return to measuring from the start
zero.
Inspection Overview
The SeeSnake CS6 can be used for basic or ad-
vanced pipe inspections. To perform a basic in-
spection, connect the CS6 to a SeeSnake camera
reel, power on the system, push the push cable
through the pipe, and observe the display. An ad-
vanced inspection additionally involves capturing
media and delivering reports to your customer.
1. Place the SeeSnake camera reel and the
CS6 near the pipe entrance.
2. Connect the CS6 to the camera reel with the
system cable.
3. Press the Power key to power on the sys-
tem. Alternatively, insert a USB drive into the
monitor’s USB port and press the Autolog key
to quick-start the inspection.
4. Carefully put the camera into the pipe. Pro-
tect the push cable from sharp edges at the
pipe entrance.
5. Push the camera through the pipe and ob-
serve the display.
6. Advanced Options:
• Set the system zero point, or take a tem-
porary segment distance measurement.
• Capture media.
• Add custom overlay.
• Locate an inspection point or path.
• Review the job, playback captured media,
and preview the report.
7. Deliver the USB drive directly to your custom-
er or insert the USB drive into your computer
to edit in HQ.