Operator`s manual
Ridge Tool Company
29
Close or Pause a Job
If you try to power OFF the CS1000 when a Job is
open you will be asked if you want to Close or Pause
the job before powering down� Your choice will depend
on what you want to have happen the next time you
power ON the CS1000�
Figure 54 – Close or Pause a Job
• Close Job and Power Down - Choosing this will
close the job and turn OFF the CS1000� If you
want to resume the job after this you will need to
select if from your Resume Job list�
• Pause Job and Power Down - Choosing this will
Pause the job and turn OFF the CS1000� The next
time you turn the CS1000 ON you will be asked
automatically if you want to resume your paused
job� This is especially convenient if you want to
take a quick break without using your batteries up
or when you want to move to a new inspection
entry point at the same job location�
Recycling Jobs
Jobs can be removed from the Job Browser by sending
them to the Recycle Bin�
1� Open the Job Browser by either pressing the:
• Menu Key
, and then using the right
Arrow Key
, navigate to the Job Browser
icon
Arrow Key
� Then press the Select Key to
open the Job Browser�
• Job Manager Key
, and then using the
down Arrow Key
, navigate to “Browse
Reports�” Then press the Select Key
to
open the Job Browser�
2� Use the Select Key
to check and uncheck
the boxes in the left column� Check the Jobs you
want to recycle and uncheck the Jobs you want
to leave in the Job Browser�
Figure 55 – Select Jobs to Recycle
3� Then use the right Arrow Key to navigate to
the Recycle button and press the Select Key
�
To exit the Job Browser without recycling any Jobs,
navigate to the Back button in the lower right corner,
press the Menu Key
on the keypad�
Conguring the CS1000
OnceyourCS1000iscongureditwillsavethesettings
you have chosen and use them every time you start
the system up�
Main Menu
Press the Menu Key to access the Main Menu�
Figure 56 – Main Menu