Operator`s manual

Ridge Tool Company
23
additional details and return you to Live View�
• To customize or add on to an Issue Tag’s
description use the right Arrow Key
to
navigate into the text box and the keyboard to
make your edits� After making your changes
press the Select Key
to Save the edited
Issue Tag return to Live View�
Figure 36 – Adding a Text Note to an Existing Issue Tag
• You can add multiple issue tags to a single
photo� After selecting your rst Issue Tag,
instead of pressing the Select Key
again
to commit it and return to Live View, press
the up Arrow Key
to navigate from the
Save button to the Add Issue Tag button
and press the Select Key to add as many
issue tags to the photo as you would like�
These will show up in the report in the order
added�
Photos can be saved to the job without adding a note or
issue tag by simply pressing the Select Key
when
yourstgettotheIssueTag andNoteScreen.
You can also exit the Issue Tag and Note Screen without
saving the photo, any notes, or tags by using the down
Arrow Key
to move to highlight the Cancel button
and then pressing the Select Key .
Annotating an Inspection by Voice
Whenever the CS1000 microphone is on, the screen
icon for the microphone will be gold to indicate its state�
Figure 37 – Microphone Icon (ON - left, Muted - right)
The microphone can be muted and unmuted by
pressing the Microphone Mute Key
, which will
make the screen icon will toggle on and off to indicate
the state of the microphone�
Figure 38 – Microphone on keyboard
When the microphone is ON, any comments made
during Autolog or Video capture will be recorded and
attached to the video clip in the report�
You can mute the microphone at any point during a
video or Autolog recording, without affecting the video�
This enables you to turn the sound recording off during
portions of the video where you are not speaking
directly to the customer, thus eliminating unwanted
sounds or remarks from becoming part of the report or
Joble.
Adding a New Session
It will sometimes occur that you want to do more than
one inspection for the same job� For example, you
may want to inspect a homeowner’s kitchen drain,
basement drain and roof vent all in one visit to discover
the cause of a problem�
To add a new session to a job:
1� Press the Job Manager Key
�
2� Use the down Arrow Key
to navigate to “New
Session�”
3� With the blue highlight around “New Session”
press the Select Key
�