Operator`s manual

English - 7
TM
• Clear, level, stable dry place for operator� Do not
use the machine while standing in water�
• If using external power, clear path to the electrical
outlet that does not contain any potential sources
of damage for the power cord�
2� Inspect the work and determine the correct RIDGID
equipment for the task� Using incorrect equipment
for an application can cause injury or equipment
damage� For a complete list of RIDGID inspection
equipment, consult the Ridge Tool Catalog at
www�ridgid�com or www�ridgid�eu�
3� Ensure the equipment has been inspected as
specified by the operator’s manual�
4� Evaluate the work area and erect barriers as
necessary to keep bystanders away� Bystanders
can distract the operator during use� If working
near traffic, erect cones or other barriers to alert
drivers�
5� Remove fixtures such as the water closet or sink to
allow access as required�
CS10 Placement
Place the CS10 in an area and in a position that allows
easy access and viewing while manipulating the camera
and push cable during an inspection� To reduce the risk
of electrical shock and equipment damage, ensure the
location is dry and that the CS10 and other equipment
will not get wet during use� The CS10 is not waterproof
and exposure to wet conditions can cause electrical
shock or equipment damage�
Place camera and the SeeSnake Reel as instructed in
the operator’s manual� Ensure the CS10 and SeeSnake
Reel are stable�
Tilt Stand
1
2
Figure 6 – Setting Up the Tilt Stand
To set up the tilt stand, perform the following:
1� Use the handle on the top of the CS10 to place the
unit in the desired location (See Item 1, Figure 6)�
2� Tilt the unit back slightly and pull forward on the tilt
stand until it locks in place (See Item 2, Figure 6)�
To store the tilt stand, tilt the unit back slightly, and push
the tilt stand toward the back of the unit until it lays flat
against the base of the unit�
Front Cover
The CS10 front cover serves two purposes: it protects
the unit during transport and storage, and it acts as a
sun hood to reduce glare during inspections�
Opening the Front Cover
Figure 7 – Opening the Front Cover
To open the front cover, perform the following:
1� Depress the orange Front Cover Release Buttons
on each side of the unit (See Figure 7)�
2� Raise the front cover to its uppermost position
where it will lock securely into place�
Closing the Front Cover
To close the front cover, perform the following:
Disconnect all connections, including the SeeSnake
System Cable and USB devices� Keeping clear of the
front cover, gently depress the orange buttons to drop
the cover to the lowest position� Press the cover into
place until it locks�